Roller Blind Measuring

Wall installation outside the recess::

Measure the width and height of the window recess (from the top of the recess to the window sill, or to the floor in the case of balcony doors). If the blind is to be installed higher than directly above the recess, the height should be measured to the planned mounting position.

To prevent light gaps between the recess and the blind, add at least 6 cm to the width (3 cm on each side). Depending on individual preferences, a larger width allowance may be applied.

A minimum of 10 cm must be added to the measured height.

Ceiling installation outside the recess:

Measure the width of the window recess. To prevent light gaps between the recess and the blind, add at least 6 cm to the width (3 cm on each side). Depending on individual preferences, a larger width allowance may be applied.

The height should be specified by adding 10 cm to the distance from the ceiling to the window sill, or to the floor in the case of balcony doors.

Non-standard installation (inside the window recess):

This installation method is recommended for non-opening windows, outward-opening windows, and windows where there is sufficient space inside the window recess above the window to install the blind without interfering with the window sash.

Measure the width of the window recess at its upper part, then subtract 4 cm to allow clearance for the mechanism. The resulting dimension should be rounded down to the nearest whole centimetre.

Measure the height of the window recess and add 10 cm to the obtained value.

Important:

The rolled-up blind together with the mechanism takes up approx. 7 cm, which must be taken into account when planning the installation.